MK and Write

Have emulated a USB Safenet ( SSP ) with MK 18.0.3 18.2.3 and 20.0.0 in win7 x86
Toro Sentinel Monitor V2.01 - looking at the log window it fails at Out:> Write -> Status=0x4
Software gives dongle error 4
I am thinking MK will not allow Out:> Write

I would like to emulate in 64 bit (only used x86 to get Toro Sentinel Monitor V2.01 to run )
What other options do I have ?

HGW

Update

I have tried a comercial Dongle cloning service.
Their sofware for 64bit needs to be activated before I can use it.
I dont mind paying but the only reason I need to clone my dongle is the software sold up and the new ppl closed it down.
If I can only use a cloned dongle with some registered software I could end up in the same boat.

any one got other options ?

If you post the dump and app here maybe somebody will help.

you need correct your reg-file and write WP in cell4

"sntMemory"=hex:\
xx,xx,xx,xx,00,00,--,--,00,00,00,00,00,00,11,00,\

is cell 4 the --,-- ?
When I dumpped there was no WP

xx,xx,yy,yy,00,00,00,00,--,--,......
you can see it in toro log

cell 4 ( assuming it starts at 0 ) is empty 00,00
in both the MK and dongle ( toro ) but i have noted that cell 1 ( delevoper id ) is 00,00 in MK (correct with dongle) but not in reg file

Out:> FindFirstUnit DeveloperId=xxxxx (0xyyyy) -> Status=0x0 <-------dongle
Out:> FindFirstUnit DeveloperId=0 (0x0) -> Status=0x0 <----------MK

I Think dump may not be correct

old MK is compare WP from program and WP from reg.
if you have WP=0000 then have
> Out:> Write -> Status=0x4

check log on real dongle and put WP to reg